Cp6003-sa/ra/rc ipmi firmware – Kontron CP6003-RC IPMI User Manual
Page 19
CP6003-SA/RA/RC
IPMI Firmware
ID 1045-5656, Rev. 2.0
Page 19
P R E L I M I N A R Y
[1] Has OEM extensions. Please refer to 6.1, Get Device ID Command with OEM Extensions.
Partial Add SEL Entry
40.7
Storage
45h
O / No
Delete SEL Entry
40.8
Storage
46h
O / Yes
Clear SEL
40.9
Storage
47h
O / Yes
Get SEL Time
40.10
Storage
48h
O / Yes
Set SEL Time
40.11
Storage
49h
O / Yes
Get Auxiliary Log Status
40.12
Storage
5Ah
O / No
Set Auxiliary Log Status
40.13
Storage
5Bh
O / No
LAN DEVICE COMMANDS
O
Set LAN Configuration Parameters
23.1
Transport
01h
O / Yes
Get LAN Configuration Parameters
23.2
Transport
02h
O / Yes
Suspend BMC ARPs
23.3
Transport
03h
O / No
Get IP/UDP/RMCP Statistics
23.4
Transport
04h
O / Yes
SERIAL/MODEM DEVICE COMMANDS
O
Set Serial/Modem Configuration
25.1
Transport
10h
O / No
Get Serial/Modem Configuration
25.2
Transport
11h
O / No
Set Serial/Modem Mux
25.3
Transport
12h
O / No
Get TAP Response Codes
25.4
Transport
13h
O / No
Set PPP UDP Proxy Transmit Data
25.5
Transport
14h
O / No
Get PPP UDP Proxy Transmit Data
25.6
Transport
15h
O / No
Send PPP UDP Proxy Packet
25.7
Transport
16h
O / No
Get PPP UDP Proxy Receive Data
25.8
Transport
17h
O / No
Serial/Modem Connection Active
25.9
Transport
18h
O / No
Callback
25.10
Transport
19h
O / No
Set User Callback Options
25.11
Transport
1Ah
O / No
Get User Callback Options
25.12
Transport
1Bh
O / No
SOL Activating
26.1
Transport
20h
O / Yes
Get SOL Configuration Parameters
26.2
Transport
21h
O / Yes
Set SOL Configuration Parameters
26.3
Transport
22h
O / Yes
Note ...
Some of the above-mentioned commands, such as SDR commands, work
only if the IPMI controller is configured as BMC. For further information, refer
to the IPMI specification 2.0.
Table 3:
Standard IPMI Commands (Continued)
COMMAND
IPMI 2.0
SPEC.
SECTION
NETFN
CMD
KONTRON
SUPPORT
ON IPMI
CONTROLLER