Kontron CP6003-RC IPMI - Manual (Page 18)

IPMI Firmware CP6003-SA/RA/RC
Page 18 ID 1045-5656, Rev. 2.0
P R E L I M I N A R Y
Set Sensor Event Enable 35.10 S/E 28h O / Yes
Get Sensor Event Enable 35.11 S/E 29h O / Yes
Re-arm Sensor Events 35.12 S/E 2Ah O / No
Get Sensor Event Status 35.13 S/E 2Bh O / No
Get Sensor Reading 35.14 S/E 2Dh M / Yes
Set Sensor Type 35.15 S/E 2Eh O / No
Get Sensor Type 35.16 S/E 2Fh O / No
FRU DEVICE COMMANDS M
Get FRU Inventory Area Info 34.1 Storage 10h M / Yes
Read FRU Data 34.2 Storage 11h M / Yes
Write FRU Data 34.3 Storage 12h M / Yes
SDR DEVICE COMMANDS O
Get SDR Repository Info 33.9 Storage 20h O / Yes
Get SDR Repository Allocation Info 33.10 Storage 21h O / Yes
Reserve SDR Repository 33.11 Storage 22h O / Yes
Get SDR 33.12 Storage 23h O / Yes
Add SDR 33.13 Storage 24h O / Yes
Partial Add SDR 33.14 Storage 25h O / Yes
Delete SDR 33.15 Storage 26h O / Yes
Clear SDR Repository 33.16 Storage 27h O / Yes
Get SDR Repository Time 33.17 Storage 28h O / No
Set SDR Repository Time 33.18 Storage 29h O / No
Enter SDR Repository Update Mode 33.19 Storage 2Ah O / No
Exit SDR Repository Update Mode 33.20 Storage 2Bh O / No
Run Initialization Agent 33.21 Storage 2Ch O / Yes
SEL DEVICE COMMANDS O
Get SEL Info 40.2 Storage 40h O / Yes
Get SEL Allocation Info 40.3 Storage 41h O / Yes
Reserve SEL 40.4 Storage 42h O / Yes
Get SEL Entry 40.5 Storage 43h O / Yes
Add SEL Entry 40.6 Storage 44h O / Yes
Table 3: Standard IPMI Commands (Continued)
COMMAND
IPMI 2.0
SPEC.
SECTION
NETFN CMD
KONTRON
SUPPORT
ON IPMI
CONTROLLER