4 molex power interface con2, 4 monitor and control (m/c), 1 pre-operation m/c – Kontron CP930 User Manual

Page 35: 2 operation m/c, Molex power interface con2 - 9, Monitor and control (m/c) - 9, Pre-operation m/c - 9, Operation m/c - 9, Molex power interface pinout - 9, Cp930 functional description

CP930

Functional Description

ID 26683, Rev. 01

Page 2 - 9

2.3.4

MOLEX Power Interface CON2

This connector is used for connecting the ATX power supply.

Figure 2-5: MOLEX Power Interface CON2

2.4

Monitor and Control (M/C)

Monitor and Control functions are divided essentially into Pre-operation and Operation. Pre-op-
eration M/C deals with board configuration and system requirements. Operation M/C covers di-
rect operator interfaces.

2.4.1

Pre-Operation M/C

Pre-operation M/C is a direct function of the application and the system requirements. These
requirements dictate the module configuration as well as the overall system integration. Overall
system integration and compliance with its requirements is beyond the scope of this manual.

2.4.2

Operation M/C

Operation M/C is a function of the CP930 driver software and the application. Direct interaction
by the operator is limited to the functionality provided by the LED’s assigned to the respective
Ethernet channels. These LED’s can be used to determine the basic operational status of a
channel and if data is being transferred.

Table 2-3: MOLEX Power Interface Pinout

Pin

Signal

GND