beautypg.com

Shift positions, Neutral – Jeep 2015 Cherokee - Owner Manual User Manual

Page 482

background image

The Four-Wheel Drive is fully automatic in the normal

driving mode. The Selec-Terrain buttons provide three

selectable mode positions:

• 4WD LOW
• REAR LOCK (If Equipped)
• NEUTRAL
When additional traction is required, the 4WD LOW

range position can be used to provide an additional gear

reduction which allows for increased torque to be deliv-

ered to both the front and rear wheels. 4WD LOW is

intended for loose, slippery road surfaces only. Driving in

4WD LOW on dry, hard-surfaced roads may cause in-

creased tire wear and damage to driveline components.
When operating your vehicle in 4WD LOW, the engine

speed is approximately three times that of the normal

driving mode at a given road speed. Take care not to

overspeed the engine and do not exceed 25 mph

(40 km/h).
Proper operation of four-wheel drive vehicles depends

on tires of equal size, type, and circumference on each

wheel. Any difference will adversely affect shifting and

cause damage to the driveline components.
Because four-wheel drive provides improved traction,

there is a tendency to exceed safe turning and stopping

speeds. Do not go faster than road conditions permit.

Shift Positions

For additional information on the appropriate use of each

4WD system mode position, see the information below:
NEUTRAL
This range disengages the driveline from the powertrain.

It is to be used for flat towing behind another vehicle.

480 STARTING AND OPERATING