Jeep 2015 Cherokee - Owner Manual - Manual (Page 252)

When the ParkSense® switch is pushed to disable the
system, the instrument cluster will display the
“PARKSENSE OFF” message for approximately five sec-
onds. Refer to “Electronic Vehicle Information Center
(EVIC)” in “Understanding Your Instrument Panel” or
“Driver Information Display (DID)” for further informa-
tion. When the shift lever is moved to REVERSE and the
system is disabled, the EVIC/DID will display the
“PARKSENSE OFF” message for as long as the vehicle is
in REVERSE.
The ParkSense® switch LED will be ON when
ParkSense® is disabled or requires service. The
ParkSense® switch LED will be OFF when the system is
enabled. If the ParkSense® switch is pushed, and re-
quires service, the ParkSense® switch LED will blink
momentarily, and then the LED will be ON.
Service The ParkSense® Park Assist System
During vehicle start up, when the ParkSense® System
has detected a faulted condition, the instrument cluster
will actuate a single chime, once per ignition cycle, and it
will display the ЉPARKSENSE UNAVAILABLE WIPE
REAR SENSORSЉ, ЉPARKSENSE UNAVAILABLE WIPE
FRONT SENSORSЉ, or the ЉPARKSENSE UNAVAIL-
ABLE SERVICE REQUIREDЉ message for five seconds.
When the shift lever/gear selector is moved to Reverse
and the system has detected a faulted condition, the
Electronic Vehicle Information Center (EVIC) or Driver
Information Display (DID) will display a ЉPARKSENSE
UNAVAILABLE WIPE REAR SENSORSЉ, ЉPARKSENSE
UNAVAILABLE WIPE FRONT SENSORSЉ or
Љ PARKSENSE UNAVAILABLE SERVICE REQUIREDЉ
pop up message for five seconds. After five seconds, a car
graphic will be displayed with ЉUNAVAILABLEЉ at ei-
ther the front or rear sensor location depending on where
the fault is detected. The system will continue to provide
250 UNDERSTANDING THE FEATURES OF YOUR VEHICLE