ISSPRO R72023 - Manual

WIRE INSTALLATION TOOL INSTRUCTIONS (R72023)
Models: ANY PERFORMAX OR EV 2 GAUGE
1
Note the side of the tool with the raised pegs (arrows in Fig 1
& Fig 2). This corresponds to pin #6 (EV2) or #4
(Performax) on the connector.
2
Place the wires in the slots of the tool, starting with pin #6
(or #4).
3
Place the connector over the wires and the tool, making sure
pin #6 (or #4) is at the side with the raised pegs, and keeping
the wires in the slots.
4
Using pliers, carefully squeeze the connector into the
insertion tool, until it is fully seated and all the wires are
pushed into their slots in the connectors (Fig 2).
Note: Fig 2 shows an EV2 6-pin connector. The insertion
tool is compatible with Performax 4-pin connectors.
Form No. IS190 (Rev. B 05/29/2009 )
ISSPRO, INC.  2515 N.E. Riverside Way  Post Office Box 11177  Portland, Oregon 97211-1899
503-288-4488  800-888-8065  Fax: 503-249-2999 www.isspro.com © 2008 ISSPRO, Inc. All Rights Reserved.
WIRE INSTALLATION TOOL INSTRUCTIONS (R72023)
Models: ANY PERFORMAX OR EV 2 GAUGE
1
Note the side of the tool with the raised pegs (arrows in Fig 1
& Fig 2). This corresponds to pin #6 (EV2) or #4
(Performax) on the connector.
2
Place the wires in the slots of the tool, starting with pin #6
(or #4).
3
Place the connector over the wires and the tool, making sure
pin #6 (or #4) is at the side with the raised pegs, and keeping
the wires in the slots.
4
Using pliers, carefully squeeze the connector into the
insertion tool, until it is fully seated and all the wires are
pushed into their slots in the connectors (Fig 2).
Note: Fig 2 shows an EV2 6-pin connector. The insertion
tool is compatible with Performax 4-pin connectors.
Form No. IS190 (Rev. B 05/29/2009 )
ISSPRO, INC.  2515 N.E. Riverside Way  Post Office Box 11177  Portland, Oregon 97211-1899
503-288-4488  800-888-8065  Fax: 503-249-2999 www.isspro.com © 2008 ISSPRO, Inc. All Rights Reserved.
Figure 1
Figure 2
Figure 1
Figure 2