Gastroback 40979 Design Stand Mixer Advanced Pro - Manual (Page 5)

33
• Ensure the mixer motor head is locked into the horizontal (closed) position when not in use
and before storing.
• Always ensure the control dial is in the ‘Off’ position, the power is switched off at the po-
wer outlet and the power cord is unplugged from the power outlet before attempting to move
the stand mixer, before assembling or disassembling, when not in use and before cleaning
or storing.
• Do not move the stand mixer whilst in operation.
• Do not leave the stand mixer unattended when in use.
• Do not place any part of the stand mixer in the dishwasher other than the bowl, splash
guard, beater, dough hook and whisk.
• Do not place any part of the stand mixer in the microwave oven.
• Keep the stand mixer clean. Follow the cleaning instructions provided in this book.
Important safeguards for all electrical appliances
• Ensure that the voltage rating of your mains power supply corresponds to the voltage
requirements of the appliance (220/240 V, 50 Hz, AC). Always connect the appliance
directly to a mains power supply wall socket with protective conductor (earth/ground)
connected properly. The installation of a residual current safety switch with a maximum rated
residual operating current of 30 mA in the supplying electrical circuit is recommended. If in
doubt, contact your local electrician for further information. Do not use any multiple desk
socket.
• Do not leave the appliance unattended while connected to the power supply. Always
switch ´Off` the appliance and IMMEDIATELY unplug the appliance after operation and if it
is not in use, cleaning and/or assembling or disassembling the processing tools. Always
grasp the plug to disconnect the appliance from the power outlet.
• Always handle the power cord with care. Do not pull or strain the power cord. The power
cord may never be knotted or squeezed. Do not let the power cord hang over the edge of
the table or counter. Take care not to entangle in the power cord.
• Do not touch the appliance with wet hands to avoid risk of electric shock. Do not touch
the appliance, when it is damp or wet and connected to the mains power supply. In this
case, immediately unplug the appliance to avoid risk of electric shock and damage.
Moving parts – risks of injuries to persons
• Do not touch the assembled processing tool (whisk, beater or dough hook) with your hands
or any other objects (hair, clothes, brushes, cooking utensils), when the appliance is
connected to the power supply. Always switch ´Off` the appliance, unplug the appliance
and wait for the motor to stop, before assembling/disassembling or cleaning the appliance
and when not in use.
• ATTenTIOn: Keep hands and other utensils out of bowl while blending food to reduce
the risk of severe injury to persons or damage to the unit.
• Always handle the whole appliance with care and without violence to avoid injuries to
persons and damage.