Gastroback 40979 Design Stand Mixer Advanced Pro - Manual (Page 15)

43
´E1` error message is flashing
on the count-up/down timer
display
The stand mixer will automatically stop operating if the
motor is stalled. If this occurs, the ´E1` error message
will flash on the count-up/down timer display. This is an
electronic safety feature. This is normally a result of too
much ingredients being processed at one time. Try remo-
ving some of the ingredients from the bowl. To continue
mixing, turn the speed control dial to the off position and
unplug the stand mixer from the power outlet. Then plug
the stand mixer into the power outlet and use as normal.
´E2` error message is flashing
on the count-up/down timer
display.
This may indicate that the motor has been stressed by
overheating with excessive load. The mixer is fitted with a
selfresetting safety device which safeguards against over-
heating on the motor with excessive loads. If overheating
occurs, the mixer will automatically activate the overhe-
ating protection device and the motor will switch itself
off. When the overheating protection is activated, unplug
the mixer from the power outlet for at least 15 minutes to
allow the unit to cool. Turn the speed control dial to the
“Off” position then plug the mixer into the power outlet
and use as normal.
Noise is heard when scraper
beater is mixing
When ingredients are in the mixing bowl, the scraper
beater may make a slight noise as it scrapes the sides
and bottom of the bowl. This is normal and should not
cause concern. Do not turn the mixer on with the scraper
beater in place if the mixing bowl is empty. This will
cause the scraper beater to make a loud noise as it scra-
pes the bowl.