Gastroback 40133 Design Juicer Advanced Pro - Manual (Page 8)

• Do not immerse the motor housing or power cord in water or any other liquid. Do not
pour or drip any liquids on the motor housing or power cord. When liquids are spilled on the
motor housing, immediately unplug the appliance and dry the motor housing to avoid risk of
electric shock or fire. Do not attempt to operate the appliance, when liquids are on or in the
motor housing.
movable and Sharp-edged Parts – Risk of injuries
• The feed chute is designed exceedingly large. Never put fingers, wooden spoons or other
foreign substance (such as hair, clothing, brushes, cloths) into the feed chute when the appli-
ance is plugged into the power point.
• Always turn the appliance off, wait for the motor to stop moving and then pull the plug
before taking off the lid of the juicer.
• Only use the provided food pusher to push food through the feed chute.
• Never hold your face or other body parts over the feed chute when the motor is running
because little pieces of food could be thrown out of the feed chute.
• The blades on the base of the stainless steel micro mesh filter and inside the feed chute are
very sharp. Pay attention when handling the units. Only touch the stainless steel micro mesh
filter on the edge and handle with care when cleaning with the nylon bristle brush. Only store
the appliance completely assembled. This way the blades will be out of reach.
• Never put foreign substance or hard objects into the feed chute. Remove all inedible parts
(such as stem, hard peeling and seeds) of the food before putting them into the feed chute.
• The motor pursues running for a little while after turning the appliance off. Wait until the
motor stops running completely before you open or move the appliance.
TeChniCAl SPeCifiCATiOnS
Model: Art. No.: 40133 Design Juicer Advanced Pro
Power supply: 230-240 V AC, 50/60 Hz
Maximum power consumption: 1.380 - 1.500 W
Length of power cord: approx. 100 cm
Weight: approx. 7 kg
Dimensions: approx. 350 x 220 x 430 mm (W x D x H)
Revolutions: 6,500 bis 13,000 per minute
Certification:
These specifications may change without notice.
38