Gastroback 40133 Design Juicer Advanced Pro - Manual (Page 5)

imPORTAnT SAfeGuARDS
Carefully read all instructions before operating and save the instructions for further reference.
Do not attempt to use this appliance for any other than the intended use, described in these
instructions. Any other use, especially misuse, can cause severe injury or damage by electric
shock, fire or moving mechanical parts. This instruction is an essential part of the appliance.
When passing on the appliance to a third person, ensure to include these instructions. never
leave the appliance unattended when in operational mode.
Any operation, repair and technical maintenance of the appliance or any part of it other than
described in these instructions may only be performed at an authorised service centre. Please
contact your vendor.
important instructions
• Always make sure the appliance is properly and completely assembled before connecting
to power outlet and operating. The unit will not turn ‘ON’ unless properly assembled.
• never leave the appliance unattended when in operational mode.
• Do not let the motor run permanently for longer then 7 minutes to avoid overheating.
• Do not operate the appliance continuously on heavy loads for more than 1 minute. The
Design Juicer Advanced Pro is fitted with a safety device which safeguards against overheat-
ing with excessive loads. If this occurs, the juicer will automatically activate the overload pro-
tection button and the unit will switch itself off. If this occurs turn the power OFF at the power
outlet and allow the unit to cool down. Then press the overload protection button found on
the bottom of the motor base. The safety device will then be reset and the juicer is ready for
use again.
• ATTenTiOn: Extra wide feed chute. Never put fingers, wooden spoons or other foreign
substance (such as hair, clothing, brushes, cloths) into the feed chute when the appliance is
plugged into the power point. Do not push products into the feed chute with your fingers or
other foreign substances. Always use the food pusher provided. Always turn the appliance off,
wait for the motor to stop moving and then pull the plug before taking off the lid of the juicer.
• Do not push products into the feed chute with your fingers or foreign objects. Always use
the food pusher provided.
• Never hold your face or other body parts over the feed chute when the motor is running
because little pieces of food could be thrown out of the feed chute.
•
wARninG: The blades on the base of the stainless steel micro mesh filter and inside the
feed chute are very sharp. Pay attention when handling the units. Only touch the stainless steel
micro mesh filter on the edge and handle with care when cleaning with the nylon bristle brush.
• ATTenTiOn: Ensure that the filter basket is clean before starting to operate the appliance.
Do not leave food leftovers dehumidify on the appliance or units of the appliance. If pulp
dehumidifies on the micro mesh filter it may clog the fine pores of the micro mesh filter thereby
lessening the effectiveness of the juicer.
• note: The juice jug lid can be used to avoid any splatter.
• ATTENTION: Empty the pulp container and juice jug in time to avoid run-over and splatter
which might causes damages to the appliance.
• Never clean the motor block in the dishwasher.
• Always turn the appliance off and pull the plug when the appliance is not in use or when
disassembling, moving or cleaning the appliance.
35