Gastroback 40138 Design Multi Juicer Digital - Smoothie User Manual

Page 16

attention: Do not allow the pulp container to overfill as this may affect the operation

of the appliance (refer to disassembling instructions). Reassemble the machine to continue

juicing. To minimise cleaning, line the pulp container with a plastic freezer bag to collect

the pulp. Pulp can then be used in other dishes, or as compost for the garden or discarded.
Step 6:

There will be no pulp extracted into Pulp Container. Some fruit may be left in the juice coll-

ector. This is normal. The amount left over will vary depending on ripeness and hardness

of fruit.

empty the pulp container during juicing

The pulp container can be emptied during juicing by turning the appliance ‘Off’ at the

control panel and then carefully removing the pulp container. Remove the pulp container

by tilting the pulp container slightly to the right and unlatch it from under the juicer cover

and the container support extending from under the motor base. Replace the empty pulp

container into position before continuing to juice.

overheat protection

The Juicer will automatically stop operating if the motor is

stalled for more than 10 seconds. This is a safety feature.

Either too much food is being processed at one time or the

pieces are not small enough. Try trimming food, cutting food

into smaller pieces of even size and or processing a smaller

amount per batch. To continue juicing, reset the appliance

by pressing the ‘On/Off’ switch on the control panel to ‘Off’,

then turn the appliance back on by pressing the ‘On/Off’

switch to ‘On’.

Disassembling your Juicer

warninG: Always turn the appliance off and pull the plug

when the appliance is not in use or when disassembling,

moving or cleaning the appliance.
Step 1:

Ensure the appliance is turned off by pressing the ‘On/Off’

switch on the control panel to ‘Off’. Then switch the app-

liance off at the power outlet and unplug the cord.
Step 2:

Remove the pulp container by tilting the pulp container

slightly to the right and unlatch it from under the juicer cover

and the container support extending from under the motor

base (picture A).
Step 3:

Use the grip handle located on the safety locking arm to lift

the locking arm from the juicer cover and lower down out of

position (picture B).
Step 4:

Lift the juicer cover off the juicer (picture C).