FEBCO AGD-L Air Gap Drains User Manual

Series agd-l, Air gap drain, Installation instructions

NOTICE

The air gap drain is not designed to catch the maximum discharge possible

from the relief valve. The installation of FEBCO air gap with the drain line

terminating above a floor drain will handle any normal discharge or nui-

sance spitting through the relief valve. However, floor drain size may need

to be designed to prevent water damage caused by a catastrophic failure

condition. Do not reduce the size of the drain line from the air gap fitting.

NOTICE

Some earlier units of the relief valve were not pre-drilled. For these units,

drill a

⁄

inch diameter hole on each side of the discharge port, located

⁄

inch up from the edge, and centered on the width.

NOTICE

Drain funnel was not designed to, nor is it able to support drainpipe

weight. Support the drain piping by other appropriate means.

NOTICE

The air gap drain is designed to drain away minimal discharge from the

relief valve port. It is not intended to drain all discharge possible from the

relief valve port.

IS-F-AGD-L

I N S T A L L A T I O N I N S T R U C T I O N S

Series AGD-L

Air Gap Drain

Sizes: 2

⁄

" – 10"

IS-F-AGD-L 1330

EDP# 980012

Limited Warranty: FEBCO (the “Company”) warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date of original shipment.

In the event of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.

THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER

WARRANTIES, EXPRESS OR IMPLIED. THE COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED

WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.

The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, special

or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting

from labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has no

control. This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.

Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages. Therefore the above

limitations may not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You should consult applicable state laws to

determine your rights.

SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES OF

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.

WARNING: This product contains chemicals known to the

State of California to cause cancer and birth defects or

other reproductive harm.

For more information: www.watts.com/prop65

A Watts Water Technologies Company

USA: Tel: (559) 441-5300 • Fax: (559) 441-5301 • www.FEBCOonline.com
Canada: Tel: (905) 332-4090 • Fax: (905) 332-7068 • www.FEBCOonline.ca

Installation Instructions

1) Attach the two straps to the inside diameter of the air gap drain funnel

using two of the screws and nuts supplied.

2) Attach the straps to the outside of the rectangular discharge port of the

relief valve using two of the screws and nuts. The relief valve is pre-

drilled for attaching the straps.

3) Thread drain piping into the 2" IPS connection in the drain.
4) The unit should be installed near a floor drain sized to adequately handle

maximum relief port discharge if installed in an indoor installation. Write

or call for FEBCO information chart RVDR (relief valve discharge rates).

WARNING

Read this Manual BEFORE using this equipment.
Failure to read and follow all safety and use information

can result in death, serious personal injury, property

damage, or damage to the equipment.
Keep this Manual for future reference.

You are required to consult the local building and plumb-

ing codes prior to installation. If the information in this

manual is not consistent with local building or plumbing

codes, the local codes should be followed. Inquire with

governing authorities for additional local requirements.

WARNING