ETS-Lindgren FP5080 Isotropic Electric Field Probe (Archived) - Manual (Page 31)

NiCd Battery Fast Charger
© ETS-LINDGREN L.P. – December 2004
REV B- PN H-600086
7. APPENDIX B:
HI-4450/FP2080/FP4080/FP5080
OPERATING PROTOCOLS
The information in this appendix assumes that you have
purchased the optional HI-4413G Fiber Optic/RS232 Interface,
and are capable of communicating directly with the HI-
4450/FP2080/FP4080/FP5080 probe via computer. No system
readout is required when using this configuration.
COMMUNICATION PROTOCOL
Data Type: RS-232 Serial
Data Mode: Asynchronous
Word Length: 7 bit
Parity: Odd
Stop Bits: 1
Data Rate: 9600 baud
INFORMATION TRANSFER PROToCOL
The HI-4450/FP2080/FP4080/FP5080 operates as a Controller
Mode device. This probe only responds to commands from
another device; it transmits no data without receiving instructions
to do so.
COMMAND STRUCTURE
A command to an HI-4450/FP2080/FP4080/FP5080 probe
consists of
1) A command letter, followed by
2) Possible
parameters
3) Terminated with a carriage return
Archived 4/02/10