ETS-Lindgren FP5080 Isotropic Electric Field Probe (Archived) - Manual (Page 22)

Isotropic Electric Field Probe
© ETS-Lindgren, June, 2005
Revision F, Part # H-600057
22
nature of the conversation. Include the serial number of the item
being returned.
Step 3. Package the system or component carefully. Use the
original packing boxes and materials, if possible.
NOTE: If your probe is calibrated in accordance with
MIL-Std-45662A, it is to your benefit to retain the original
shipping box and packing materials. One of the criteria
for certifying a calibration to MIL standards requires
ETS-Lindgren to always ship equipment in the specified
packaging. When a MIL Standard instrument is sent to
ETS-Lindgren in other packaging, we must replace it
with the specified packaging materials for return
shipment. YOU WILL BE BILLED FOR THE NEW
PACKAGING.
If the probe is under warranty, refer to the Limited Warranty
section of this manual for additional information about your
return.
PERIODIC/PREVENTIVE MAINTENANCE
The HI-4450/FP2080/FP4080/FP5080 probe assembly (sensor
and electronics housing) requires an annual calibration to verify
that they are performing within specifications. ETS-Lindgren
service personnel may perform this calibration at the factory.
Return your probe(s), using the original packing materials (if
possible), to:
ETS-Lindgren
Attn. Service Department
1301 Arrow Point Drive
Cedar Park, Texas, USA 78613
Archived 4/02/10