ETS-Lindgren 5503 Electric Field Generator - Manual (Page 18)

18 | Assembly and Installation
Each cable is terminated at a post on the load box or balun box. Only one cable
may be connected to each post. Secure the cable into place with a wing nut.
To connect the cables:
1. Loosen the knob clamp on the antenna element around the cable.
2. Pull the connecting loop out from the element and over to the
corresponding connection post on the load box or balun box.
3. Remove the nut and the top washer from the post and slide the
connecting loop into place on the post then replace the washer and nut.
Securely tighten the nut for good contact.
4. Tighten the knob clamp on the antenna element around the cable.