ETS-Lindgren 5411 GTEM! Test Cell - Manual (Page 18)

18 |
Maintenance
Make sure to install the finger stock gasket properly at the corners, as shown.
See Tips on page 20 for additional information.
2.
(B)
Insert the second row of finger stock gasket into the inner side.
You may use the flat edge of a screwdriver or another type of flat edge to
tuck the gasket into the channel.
3.
(C)(D)(E)(F)
Repeat steps 1 and 2 for the bottom and top until
two rows of new gasket is installed around the entire perimeter of
the channel.
1.
(A)
Starting with the outer side, insert
one row of finger stock gasket
(part# 890471) into the channel with the
fingers facing outward and with the back
of the gasket flush against the side of the
channel.