ETS-Lindgren 5411 GTEM! Test Cell - Manual (Page 16)

16 |
Maintenance
Finger Stock Gasket
A large amount of finger stock is
used in the construction of the
GTEM!. Some of this finger stock
is accessible in the normal course
of GTEM! operation. Periodic
visual inspections must be made
to determine if there is need to
clean the finger stock, or to
replace it if damaged.
Replacement finger stock for the
doors is available from the
factory; replacement finger stock
for the connector panels and the
load board access panels is also
available.
Side view Back view
C
LEANING
F
INGER
S
TOCK
To clean finger stock, use an aerosol lubricant to loosen the debris, and then
low-pressure air or another aerosol to remove the excess lubricant. Alternatively,
a soft rag may be used to remove dirt and excess liquid from the finger stock.