EFCO S5600 Slope Glazed - Manual (Page 6)

EFCO CORPORATION 6/2012 PART NO. Y308 Page 6 of 23
Series 5600 Slope Glazed Curtain Wall Installation Instructions
Section III: End Cap Installation
End Cap Installation
of mullion
Inside edge
[FIG. 3]
1"
5"
1/8"
A.) Seal joint between gutter and end cap as shown. When jamb condition is exposed
(end wall condition), use a 3/8” diameter X 3” long countersunk bolt to secure the
lower rafter clip to the gutter clip. This will allow for overlap of flashing as
designed.
End cap as designed
on a per job basis.
End cap
Location of gutter
once installed on top
of vertical mullion.
#8 Flat head
countersunk screws.
T.O. Mullion