Dynojet Data Link Module - OBDII - Manual (Page 9)

D A T A L I N K M O D U L E - O B D I I
DJDLM-OBDII Setup
Version 4 Data Link Module-OBDII Installation and User Guide
5
C ONFIGURING THE DJDLM-OBDII
1 Start the WinPEP software by double-clicking the desktop icon or by selecting
Start
! All Programs ! WinPEP 7 ! WinPEP 7.
When WinPEP starts, the Graph View shows by default.
2 Click the MakeRun button on the toolbar or select Display ! MakeRun
Screen from the menu choices.
3 Verify your computer is connected to the dyno electronics and the dyno
electronics is powered on. Refer to "Connecting the Dyno Electronics" in your
WinPEP 7 User Guide for more information.
4 Click the MakeRun Configuration button .
Note: If You may have more than one DJDLM-OBDII connected to your network
at the same time, a window will pop up. Choose which device you wish to
connect to.
5 Click the Expansion Systems tab.
6 Select Dynojet DLM-OBDII.
7 Click the Configure button.
Figure 2: MakeRun Configuration—Expansion Systems
configure
button
expansion
systems tab
select Dynojet
DLM-OBDII