Introduction – Dynojet Data Link Module - OBDII User Manual
Page 6

Data Link Module-OBDII Installation and User Guide
D A T A L I N K M O D U L E - O B D I I
Introduction
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INTRODUCTION
Before you begin using WinPEP 7 (Performance Evaluation Program for Windows)
with your DJDLM-OBDII, be sure to read this guide for important system
requirements and installation instructions. Refer to the Dynojet WinPEP 7 User Guide
(P/N 98118103) for detailed information about WinPEP 7 features and commands, a
theoretical background, and a hands-on tutorial.
C
OMPUTER
S
PECIFICATIONS
You will need to provide a computer system to run the WinPEP software.
minimum system requirements
recommended systems requirements
• Microsoft® Windows 2000/XP
• Microsoft® Windows 2000/XP
• Pentium 800 MHz Processor
• 2.4 GHz Processor or greater
• 256 MB of available RAM
• 512 MB of available RAM or greater
• one 9-pin COM port, two 9-pin COM ports for
Tuning Link
• one 9-pin COM port, two 9-pin COM ports for
Tuning Link
• USB port for DJDLM-OBDII, additional USB
ports may be desired for other accessories
• USB port for DJDLM-OBDII, additional USB ports
may be desired for other accessories
• 800 x 600, 256 color monitor (SVGA)
• 1280 x 1024 256 color monitor (SXGA) or better
• 1.2 gigabyte hard drive
• 40 gigabyte hard drive
• 30 MB of available hard-disk space
• 100 MB of available hard-disk space
• CD ROM
• CD ROM
• printer, if hard copies are needed
• printer, if hard copies are needed
• wired or wireless network capability
• wireless network capability