Dynojet 248x: DynoTRAC User Guide with Variable Brake - Manual (Page 12)

10 Document #98111100
Brake Over Heating
The DynoWare EX+ electronics continuously
monitors the brake temperature. If the brake
temperature approaches an unsafe limit, the brake
gauge perimeter will begin flashing red. Should
this occur, stop testing and allow the brake to cool
to a normal operating temperature, as indicated by
the temperature gauge.
Warning!! If the brake temperature exceeds a safe
operating limit,
the brake will be
deactivated.
If the brake temperature exceeds the safety limit
the gauge perimeter will remain red and the Brake
Gauge will become the active gauge. The target
value will be set to 0 (no braking). Click off the
brake on the remote pendant. When the
temperature of the brake has cooled sufficiently,
the brake gauge will return to normal. Normal
testing may now be resumed.