Dynojet 248x: DynoTRAC User Guide with Variable Brake User Manual

Page 11

Text mode
Original mode

Document #98111100 9

Put the vehicle in gear to begin the test. Shift
up to the desired test gear and press the brake
button on the Remote Pendant.

As the target RPM is approached the brake will
begin to engage. The amount or percentage of
braking will depend on the power of the engine
being tested and the test gear.

Note:

As a safety precaution, if you change
modes (select another gauge) while the
brake button is pressed, the current value
in the gauge will be copied to the Target
Value Text Box.

Emergency Stop

In an emergency, the brake can be set to 100% by

clicking on the STOP button or pressing the

Space Bar on the keyboard. Refer to the screen on

the next page:

This manual is related to the following products:

248: DynoTRAC User Guide with Variable Brake