Dynojet 224: Pit Installation Guide - Manual (Page 22)

In Ground Model 224 Automotive Dynamometer Installation Guide
C H A P T E R 2
Unpacking and Inspecting the Dyno
2-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
UNPACKING AND INSPECTING THE DYNO
When you receive your dyno, examine the exterior of the shipping container for any
visible damage. If damage is detected at this stage, contact the shipper or Dynojet
before proceeding with unpacking.
Use the following steps to unload your dyno. You will need to provide equipment
capable of lifting a minimum of 2,722 kg. (6,000 lb.) to move the crated dyno into
position in your dyno room. Refer to “Forklift Requirements” on page 1-8 for more
information.
1
Move the crated dyno to a clear area near your dyno room.
2 Using a pry bar, or a large flat screwdriver, and a hammer, remove the top and
sides of the crate.
3 Inspect the exterior of the dyno for any indications of damage. Report any
damage immediately.
4 Remove the pit covers from the crate.
Note: You will only have the pit covers if you ordered the Pit Cover Set.
5 Remove the boxes and loose parts from the crate, verify their condition and
contents and set them aside.
part description part description
chock (4)
P/N 2A092
cable, drum/data acq., 24"
P/N 66954001
axle strap, 21" (4)
P/N 30AS21
dyno electronics
P/N 76199001
anchor, redhead, 3/8" (4)
P/N 37513200
pendant and cable
P/N DC100-104
tool, redhead anchor install
P/N 37518200
secondary inductive pickup,
20’ (2)
P/N DE100-109S