Dynojet 224: Pit Installation Guide - Manual (Page 15)

S P E C I F I C A T I O N S A N D O P E R A T I N G R E Q U I R E M E N T S
Dynamometer Specifications and Requirements
Version 4 In Ground Model 224 Automotive Dynamometer Installation Guide
1-7
C OMPRESSED A IR
The following requirements are needed for the air brake:
• Clean and dry air, between 100-140 psi
• shut off valve
• 1/4-inch NPT pipe thread connector (to attach air to the dyno), if air hose does not
have a 3/8-inch inside diameter
C OMPUTER S PECIFICATIONS
You will need to provide a computer system to run the WinPEP software. A complete
list of system requirements can be found in your WinPEP 7 User Guide. This manual is
included with your dyno and is also available on your WinPEP 7 CD.
E LECTRICAL R EQUIREMENTS
description specifications
Power Requirements: 4WD electronics 110v 60Hz or 240v 50Hz
Power Requirements: dyno electronics 110v 60Hz or 240v 50Hz
Power Requirements: air pump 110v 60Hz or 240v 50Hz
Power Requirements: computer 110v 60Hz or 240v 50Hz
Power Requirements: optional eddy
current brake
240v 30amp single phase circuit for each eddy current
brake
Refer to the Eddy Current Brake Installation and User
Guide for Model 224 In Ground Automotive
Dynamometers (P/N 98215101) for more information.