Dynojet 224: Pit Installation Guide - Manual (Page 16)

In Ground Model 224 Automotive Dynamometer Installation Guide
C H A P T E R 1
Dynamometer Specifications and Requirements
1-8
E NVIRONMENTAL R EQUIREMENTS
F IRE S UPPRESSION
Always have adequate fire suppression or fire extinguishers in your dyno room.
F ORKLIFT R EQUIREMENTS
You will need to provide equipment capable of lifting a minimum of 2,722 kg.
(6,000 lb.) to lift the dyno off the crate and into position in your dyno room. You will
also need a pair of straps capable of supporting 2,722 kg. (6,000 lb.) to attach to the
dyno. Dynojet recommends using two 2-inch x 6-foot single loop style straps; these
straps must be the same length.
G ROUND H OOKS
Your pit cover set includes ten ground hooks. The ground hooks allow you to secure
your car in place using the tie-down straps. The layout of the ground hooks is
described in the pit dimensions (P/N 98219103) provided by your salesperson. Refer
to Appendix A for red head anchor installation instructions.
Note: You will only have the ground hooks if you ordered the Pit Cover Set.
P HONE AND I NTERNET A CCESS
Dynojet recommends you have a phone close to the dyno to call for assistance in an
emergency. You may also wish to contact Dynojet to troubleshoot your dyno.
Internet access on your computer is desirable for contacting Dynojet and
downloading new information and updates.
T IE -D OWN S TRAPS
Dynojet recommends using tie-down straps for securing the car on the dyno. The 224
dyno comes with an automotive tie-down package.
description specifications
Temperature
operating min./max 10°C/50°C (50°F/122°F)
storage min./max 0°C/70°C (32°F/158°F)
Humidity 0 to 95% non condensing