Coral Industries Hyaline Swing Door/ILP (1/4 Frameless) - 6N0 - Manual (Page 7)

6N0 6/09
B
D
Wall
Jamb
Header
OUTSIDE OF SHOWER
Glazing =
Measurement + 1/4"
I
Horizontal Glazing
Apply horizontal glazing (I) on inside and outside of
panel between glass and header at top of unit, and
between glass and sill at bottom of unit.
For a smoother fit in corners where horizontal and
vertical glazings meet, the ends of horizontal glazing
may be trimmed at a 45
0 angle. Only trim the exterior
ridge of glazing, not the section of glazing that fits inside
metal once installed.
Ends of Horizontal Glazing may be
trimmed at a 45
0 angle (on exterior ridge
only) for a smoother fit in corners where
vertical and horizontal glazings meet.
Exterior Ridge of Horizontal Glazing
Door Panel
Measure width of door glass at bottom.
Trim vinyl drip sweep (F) to door glass width
minus 1/8". Trim only from door hinging end of drip
sweep. Contour cut end of drip sweep fin to remove
sharp point.
Press drip sweep onto bottom edge of door glass with
fin facing inside of shower and edge of drip sweep flush
with edge of glass on hinging side of door. F
Vinyl Drip Sweep
Fin faces inside
of shower.
OUTSIDE OF SHOWER
Drip Sweep
length =
Door Width
minus 1/8"
Seal unit by caulking along outside of enclosure where
metal and bath meet, especially where sill meets
threshold. If desired, caulk inside of enclosure where
jambs meet walls.
Glass
Header
Horizontal
Glazing
13 Horizontal Glazing
(I)
14 Vinyl Drip Sweep
(F)
15 Caulking
Horizontal
Glazing