Coral Industries Steam Swing Door/ILP - 0S3 - Manual (Page 6)

0S3-GP 6/02
On opening side of door, caulk
joint on sill where magnetic door
stop and sill meet.
OUTSIDE OF SHOWER OUTSIDE OF SHOWER
A
Double
Channel Hinge
Door
Stop
Caulk
Magnetic
Door Stop
Sill
Door Panel
Sill A
Caulk
12
13
14
The use of a caulking compound will assure a water-
tight seal of your enclosure. Apply caulk along
outside edge of enclosure where metal and shower
meet, especially where sill meets threshold. If
desired, caulk inside of enclosure where jambs meet
walls.
Side
Panel
Caulk
OUTSIDE OF SHOWER
E D
Make certain that bottom channel of door is clean and dry before mounting drip rail. After mounting,
drip rail should not be removed or repositioned. Adhesive on tape needs 72 hours curing time for
maximum bond.
Aluminum drip rail may be additionally secured
by drilling with 1/8" drill bit through drip rail
into bottom channel. Attach using 8A x 3/8"
truss head screws. When drilling in door panel,
make sure drill does not hit glass. Glass is
seated approximately 1/2" into channel.
With door in closed position, place drip rail on bottom
channel of door on inside of shower. Position so that
bottom edge of sweep extends approximately 1/2"
below bottom of door.
Mark location for drip rail, peel protective cover from
tape (M) and press into place.
Insert drip rail plug (P) into groove of drip cap on
opening side of door.
P
Drip Rail
Tape
F
M
INSIDE OF SHOWER
Drip Rail Plug
1/2"
Sweep extends
1/2" below
bottom channel.
Door
Panel
Drip
Rail
On opposite side, caulk where hinge
door stop and sill meet.