Coral Industries Steam Swing Door/ILP - 0S3 - Manual (Page 4)

0S3-GP 6/02
Adjust door, side panel, double channel,
and door stops until magnetic strip aligns
properly on door panel and door closes
evenly at top and bottom.
Once desired alignment of parts has been
achieved, from inside of shower, drill four
evenly spaced holes through leg of jambs
(1/4" from edge) into side panel and hinge
door stop. Secure using 8A x 3/8" truss
head screws (K).
Secure double channel by drilling, from
inside of shower, four evenly spaced holes
(1/4" from edge) through double channel
into side panel and magnetic door stop.
Secure using 8A x 3/8" truss head screws.
Secure header by drilling, from inside of
shower, through header into jambs and
double channel. Secure using 8A x 3/8"
truss head screws.
When securing jamb and double channel to side panel, do not drill through front side of jamb or
hit glass with drill bit. (Glass is seated approximately 1/2" into channel.)
8
Jamb Double
Channel
INSIDE OF SHOWER
Side Panel
8A x 3/8 "
Truss Head
Screws
K
Header C
B
1/4"
1/4"
D
Magnetic
Door Stop
E
Position hinge door stop, which is attached
to door panel, into jamb on opposite side
from magnetic door stop. For safety
purposes, door should be installed to open
out from shower.
If magnetic strips do not seal tightly,
reverse polarity by removing strip from
door stop and replacing it with the
previous top end as the bottom end.
Hinge Door Stop
(attached to door)
Jamb
Door
Panel
OUTSIDE OF SHOWER
B
Header C
Slide magnetic door stop into double
channel with magnetic strip facing
outside of shower.
Slide vinyl steam seal (in slot of
header) to rest flush against magnetic
door stop.
Double
Channel
Jamb
OUTSIDE OF SHOWER
D B
Header C
Magnetic
Door Stop
E
Vinyl
Steam
Seal
7
6
H
Side Panel
1/4"