Coral Industries Hyaline Swing Door/DPNL (1/4 Frameless) - 6T0 - Manual (Page 7)

6T0 6/09
Measure width of door glass at bottom.
Trim vinyl drip sweep (F) to door glass width minus 1/8”.
Trim only from hinge end of drip sweep. Contour cut end
of drip sweep fin to remove sharp point.
Press drip sweep onto bottom edge of door glass with fin
facing inside of shower and edge of drip sweep flush with
edge of glass on hinge side of door. (Drip sweep will be 1/8”
from edge of glass on opening side of door.)
F
Vinyl Drip Sweep
Fin faces inside
of shower.
OUTSIDE OF SHOWER
Drip Sweep
length =
Door Width
minus 1/8"
Seal unit by caulking along outside of enclosure where
metal and bath meet, especially where sill meets threshold.
If desired, caulk inside of enclosure where jambs meet
walls.
14 Vinyl Drip Sweep
(F)
15 Caulking
Measure length of panel glass from header to sill and
add 1/4”. Cut two pieces of vertical glazing (H) and apply
on inside and outside of panel between glass and jambs.
Install glazing for both side panels working from outside to
inside of panel.
For a smoother fit in corners where horizontal and vertical
glazings meet, the ends of vertical glazing may be trimmed
at a 45
0 angle. Trim only the exterior ridge of glazing. Do
not trim glazing that fits inside metal once installed.
H
Glazing =
Measurement + 1/4"
Vertical
Glazing
OUTSIDE OF SHOWER
Vertical Glazing
Jamb
13 Vertical Glazing
(H)
Jamb
VERTICAL CROSS SECTION
Caulk
Caulk
Ends of vertical glazing may be
trimmed at a 45
0 angle (on exterior
ridge only) for a smoother fit in
corners where vertical and
horizontal glazings meet.