Code 3 WingMan with Torus - Manual (Page 7)

7
Installation Instructions-2006+ Impala-(Cont.)
Step 7 Position the Mounting Brackets with the 1/4"-20 X 2 1/2" Hex Head Bolts over the mounting holes in the rear deck and push the
bolts through the holes and through the Mounting Bracket Spacer Bushings as shown in Figure 32. Make sure the Mounting Brackets are
fairly parallel to each other after they are both in place. Thread a fender washer and a 1/4"-20 locking nut onto each of the bolts from inside
the Impala's trunk. Have an assistant using a wrench from the interior of the Impala keep the bolts from turning and tighten the Hex Nuts as
shown in Figure 33.
Step 8 Feed the WingMan's cable(s) through the cable hole and into the trunk (see Figure 34).
Step 9 Install the WingMan by positioning it over the mounting brackets. You will have to continue feeding the cable through the hole
simultaneously while positioning the bar.
Step 10 As soon as the outer panel mounting plate holes can be lined up with the holes in the mounting brackets
and the mounting holes in the WingMan Bar, insert the (4) supplied 1/4"-20 x 1/2" bolts and internal tooth lock
washers (see Figure 35). Leave the (4) bolts finger tight at this time.
Step 11 Center the lightbar in the rear window of the Impala by using a tape measure and adjust the brackets
and mounting plates so that they line up with each other.
Step 12 Tighten the 1/4"-20 X 1/2" bolts with a phillips screwdriver (see Figure 36).
FIGURE 32 FIGURE 33 FIGURE 34
FIGURE 35 FIGURE 36
The bracket fasteners make excellent hard mounting points for radar guns, video
cameras, etc.
Caution: Drilling into the housing of the light bar could damage wiring or other internal
components.