Code 3 WingMan with Torus - Manual (Page 4)

4
FIGURE 7 FIGURE 8 FIGURE 9
FIGURE 10 FIGURE 11
FIGURE 12 FIGURE 13 FIGURE 14
Step 2 Position the WingMan in the rear package tray area (see Figure 15) to determine the desired routing of the cable into the trunk or where ever
the final location of the cable is to be. Note: The best and safest cable routing is to drill a clearance hole for the cable directly through the sheet
metal and the interior fabric of the package tray area from inside the trunk of the vehicle directly in line with the cable exit of the WingMan.
This keeps the cable out of a passengers reach Note: Move the WingMan out of the way temporarily and make sure any OEM wiring is out
of the way so you don't damage the WingMan or the wiring when drilling the cable clearance hole! Route the cable through the hole, pull the
slack out of the cable, and reposition the WingMan before going to the next step.
Step 3 Remove the (2) outer plastic child restraint covers (see Figure 16). Note: If it is desired to retain the child restraint covers they will need to
be trimmed to clear the WingMan's Mounting Brackets after it is installed, other wise discard them.
Step 4 Position the Pemserted WingMan Mounting Brackets in the rear area of the child restraint pockets and line up the threaded hole in the WingMan
Mounting Bracket with the existing holes in the Dodge Charger's Sheetmetal (see Figure 17). Note: One of the tabs on the Mounting Bracket is
shorter than the other. The tab that is the shorter of the two goes into the child restraint pocket. If you have the bracket in backwards the
mounting hole will not line up with the existing hole in the vehicle's sheet metal.
Installation Instructions
Step 1 Lying inside the trunk of the vehicle facing up, look up at the inner roof of the trunk. Locate and remove the (6) Christmas Tree Fasteners (see
Figures 12 & 13) which hold the fiber upper trunk liner in place. Remove the fiber trunk liner and set it aside (see Figure 14).
2011+ DODGE CHARGER