Code 3 WingMan for Chevy Impala - Manual (Page 9)

9
This Product contains high intensity LED devices. To prevent eye damage,
DO NOT stare into light beam at close range.
LED Light Head Flash Pattern
Place the unit on a clean work surface and remove the outer cover. With the chassis facing up, locate each lighthead
module circuit board.
To change the flash patterns of the LED Light Heads, touch both posts of the J1 header
simultaneously with an electrically conductive tool such as a screw driver blade (see figure 19 below).
Repeating this proceedure allows the operator to cycle through the numerous flash patterns offered until
the desired pattern is achieved.
Operating Specifications for directional module:
Operating Voltage: 10-16 VDC, Reverse Polarity Protection
Current Draw : Flashing Module
Red/Amber - .25A avg @ 12.8 Volts
Blue/White - .4A avg @ 12.8 Volts
Steady Burn Module
Red/Amber - .5A avg @ 12.8 Volts
Blue/White - .8A avg @ 12.8 Volts
Available Colors - Red , Blue, Amber, and White
LED MODULES
Directional module Flash Pattern - Table 2
PCB
CycleFlash (DEFAULT) Quad Pop Flash75
NFPA QuadFlash75 Triple Pop Flash75
Steadyburn SingleFlash375
ModelFlash SingleFlash250
ActiveFlash SingleFlash150
FiveFlash70 FiveFlash150
QuadFlash70 QuadFlash150
TripleFlash70 DoubleFlash150
DoubleFlash70 TripleFlash150
SingleFlash75
Flash Pattern Header for OPTIX/LEDX
J1
Momentarily short and release
to change patterns