Code 3 WingMan for Chevy Impala - Manual (Page 14)

14
2006 Installation Instructions cont.
FIG. C
FIG. D
Insert the carriage bolt through the mounting
foot and rear deck. Place the fender washer
and lockwasher on the bolt and finger tighten.
Some compression of the rear deck may be
required for the carriage bolt to clear the hole.
Repeat for the second foot.
(Figure C shows the bar mounted with the feet
and brackets attached)
As shown in figures C & D, place the
WingMan ™ on the mounting feet, lining up the
protruding screws (on the WingMan bottom),
with the clearance holes on the mounting feet.
Attach a flat mounting bracket to the mounting
foot, using the supplied 1/4"x20 hardware.
Repeat for the second bracket.
Attach the
WingMan ™ to the brackets, using the remaining
two 1/4"x20 screws. Fully tighten all hardware.
NOTE: FINGER TIGHTEN ALL HARDWARE.