beautypg.com

Unpacking & pre-installation, Installation & mounting, Introduction – Code 3 WingMan for Chevy Impala User Manual

Page 2

background image

2

Unpacking & Pre-installation

Carefully remove the WingMan™ and place it on a flat surface, taking care not to scratch the lenses or damage the cable coming out of the
bottom. Examine the unit for transit damage, etc. Report any damage to the carrier and keep the shipping carton.

Standard light bars are built to operate on 12 volt D.C. negative ground (earth) vehicles. If you have an electrical system other than 12 volt
D.C. negative ground (earth), and have not ordered a specially wired light bar, contact the factory for instructions.

Test the unit before installation. To test, touch the black wire to the ground (earth) and the other wires to +12 volts D.C., in accordance with
the instructions attached to the cable (an automotive battery is preferable for this test). Some units may be factory wired for control by a LED
flasher or an ArrowStik Controller in which case the cable's wire tag should be consulted. A battery charger may be used, but please note
that some electronic options (flashers, stingrays, etc.) may not operate normally when powered by a battery charger. If problems occur at
this point, contact the factory.

Installation & Mounting

Utilizing non-factory supplied screws and/or mounting brackets and/or the improper number
of screws may result in loss of warranty coverage on the equipment.

WARNING!

!

The use of this or any warning device does not ensure that all drivers can or will observe or react to an
emergency warning signal. Never take the right-of-way for granted. It is your responsibility to be sure you can
proceed safely before entering an intersection, driving against traffic, responding at a high rate of speed, or
walking on or around traffic lanes.
The effectiveness of this warning device is highly dependent upon correct mounting and wiring. Read and follow
the manufacturer’s instructions before installing or using this device. The vehicle operator should insure daily
that all features of the device operate correctly. In use, the vehicle operator should insure the projection of the
warning signal is not blocked by vehicle components (i.e.: open trunks or compartment doors), people,
vehicles, or other obstructions.
This equipment is intended for use by authorized personnel only. It is the user’s responsibility to understand and
obey all laws regarding emergency warning devices. The user should check all applicable city, state and
federal laws and regulations.
Code 3, Inc., assumes no liability for any loss resulting from the use of this warning device.
Proper installation is vital to the performance of this warning device and the safe operation of the emergency
vehicle. It is important to recognize that the operator of the emergency vehicle is under psychological and
physiological stress caused by the emergency situation. The warning device should be installed in such a
manner as to: A) Not reduce the output performance of the system, B) Place the controls within convenient
reach of the operator so that he can operate the system without losing eye contact with the roadway.
Emergency warning devices often require high electrical voltages and/or currents. Properly protect and use
caution around live electrical connections. Grounding or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER USE OF
EMERGENCY WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY OF EMERGENCY
PERSONNEL AND THE PUBLIC.

Introduction

The WingMan™ is an interior LED lighting system that fits in the rear deck area behind the rear seat. It delivers a slim powerful warning
signal to the rear of the vehicle without obstructing the driver's rear vison.

The WingMan is designed on a modular basis, which means that the light bar can be customized to meet most any requirements. The
WingMan has room for up to eight LED lightheads. Each lighthead is individually wired for any flash pattern or combination of flash patterns
required.

WARNING!

!