Code 3 WingMan for Chevy Impala - Manual (Page 6)

6
FIGURE 15 FIGURE 14
Step 12 Install the WingMan rear bar by positioning one end in the far back corner of the rear window and carefully bring the other end
down along the roof pillar and towards the back of the car and into position over the mounting brackets (see figure 14 and 15). You will
have to continue feeding the cable through the hole simultaneously while positioning the bar.
Step 13 As soon as the outer panel mounting plate holes can be lined up with the holes in the mounting brackets
and the mounting holes in the WingMan Bar, insert the (4) supplied 1/4-20 x 1/2" bolts and internal tooth lock
washers (see figure 16). Leave the (4) bolts finger tight at this time.
Step 14 Center the light bar in the rear window of the Impala by using a tape measure and adjust the brackets
and mounting plates so that they line up with each other.
Step 15 Tighten the 1/4-20 x 1/2" bolts with a phillips screwdriver (see figure 17).
FIGURE 16 FIGURE 17