Code 3 WingMan for Chevy Impala - Manual (Page 3)

3
Mounting Hardware -
All mounting hardware is packed in a small box inside the main carton. There are two brackets
and two mounting plates used to mount the WingMan™ to the vehicle. These are discussed in detail later.
FIGURE 1
Step 2 Align the two halves of the template and tape the template together at the tape lines (see figure 2 and 3)
Note: It is helpful to tape one side of the template down to a flat surface to hold it in place while you
tape the other side to it.
FIGURE 2 FIGURE 3
Installation Instructions-
Step 1 Locate and remove the two template halves from the center page area of this manual. Cut out the two
halves of the paper template. (see figure 1)