Code 3 LED X Deck Lights - Manual (Page 5)

5
Wiring Instructions
All LED-X models are stand alone self-contained units ready for installation with no special wiring
required. They are provided with a cigarette plug designed to be used with a +12VDC fused lighter socket.
Alternately, the user can remove the plug and connect (through a properly sized fuse) to a user supplied
switch. The ribbed wire is positive (+12VDC) and the smooth wire is negative.
Operation
The LED series lightheads arrive completely assembled and ready for installation. They are designed to
function at 10 - 16 VDC.
To operate the LED-X unit, insert the cigarette plug provided into a +12VDC lighter socket and
rotate 1/4 turn to insure a good electrical connection.
Flash Patterns
LX1F-X 1 Head Model
Selecting and programming flash modes:
This unit will provide up to ten different flash modes. Each of these modes can be selected by using the momen-
tary button located on the end of the unit. Each flash mode can be selected by momentarily depressing the
button until the unit stops flashing, and then releasing. As each flash mode is selected it is automatically
programmed into the unit such that when power is removed it will always return to the selected mode the next
time power is applied. If another mode is desired, just use the momentary button to step through each mode
until the desired mode is found.
Selecting and programming Cycle Flash mode:
When shipped, the unit will be in “Cycle Flash mode”. This mode cycles through a variety of flash patterns
continuously providing an ever changing warning signal. If the unit is not in Cycle Flash, or you wish to return to
Cycle flash from another mode, then the momentary button should be depressed until the unit stops flashing,
and held on for several seconds then released. This will program cycle flash into the unit.
Flash Pattern Description
Cycle Flash Cycles through various patterns @ 70 fpm
Steady-Burn Steady-Burn
Five Flash Five Pulses per flash @ 70 fpm
Quad Flash Four Pulses per flash @ 70 fpm
Triple Flash Three Pulses per flash @ 70 fpm
Double Flash Two Pulses per flash @ 70 fpm
Fast Double Flash Two Pulses per flash @ 85 fpm
NFPA Four Pulses, 70% Duty Cycle @ 75 fpm
Quad Pop Flash Four Pulses per flash ( 3 equal, 1 extended) @ 70 fpm
Triple Pop Flash Three Pulses per flash ( 2 equal, 1 extended) @ 70 fpm
LX1SB-X 1-Head Model
This unit will provide one steady-burn operation mode. It can be used as a stationary warning light, it can also
be flashed with an external relay-based flasher.