beautypg.com

Code 3 Excalibur User Manual

Page 13

background image

13

Electronics Module Removal

In the event that the power supply or a strobe lighthead assembly must be returned to the factory for service, mark each wire
with a tag to identify each function and note the proper location before disconnecting the wiring. Figure 9 can be used to mark
the locations of the individual connections as well.

Refer to Figure 9 for power supply removal. Remove the four (4) screws holding the power supply. Disconnect the wire leads,
and move the power supply to the side. Remove the 2 screws holding the capacitor assembly and lift the strobe power supply/
capacitor assembly from the lightbar as a unit. To reinstall the power supply reverse the above steps.
Caution: Verify that wires are not pinched or damaged when reinstalling power supply.

Strobe Lighthead

Assembly

Filter

(if supplied)

FIGURE 8