Iii. installation of transducer harness – BoonDocker POLARIS: 11-12 PRO 800 Turbo 3D Tuning User Manual
Page 3
BoonDocker Performance – 2379 Heyrend Way, Idaho Falls, ID 83402 – 208-542-4411 / 877-522-7805
www.boondockers.com – email:
– fax: 208-524-7381
Revised 1-20-11
Copyright © 2010 Boondocker
Page 3 of 14
III. Installation of Transducer Harness
Two different transducer harnesses are available depending on if an EBC is being used. Both harnesses are shown below.
Install the harness according to the diagram as shown below.
Transducer Harness with EBC
Transducer Harness without EBC
Install the Transducer Harness as follows. Note: Use Dielectric Grease in all connectors to help prevent corrosion on the
terminals.
TPS
The stock throttle position sensor (TPS) is located on the PTO end of the
throttle bodies. As show in the image on the right.