BoonDocker POLARIS: 11-12 PRO 800 Turbo 3D Tuning User Manual
Page 10
BoonDocker Performance – 2379 Heyrend Way, Idaho Falls, ID 83402 – 208-542-4411 / 877-522-7805
www.boondockers.com – email:
– fax: 208-524-7381
Revised 1-20-11
Copyright © 2010 Boondocker
Page 10 of 14
RPM:
To select RPM Fuel Adjustment window, move the cursor right until it is under RPM and press “SEL”, Up
or Down Arrow. The following screen will appear:
.
RPM Min Max•
OFF← 5560 7550
RPM OFF
Shows RPM mode is OFF.
5560
Min RPM threshold
7550
Max RPM threshold
Under RPM, press the up or down button to turn this mode ON or OFF.
Move the cursor right to adjust the Minimum RPM and the Maximum RPM. If RPM mode is ON, fuel
adjustment will activate only when RPM is between these values.
Press the “SEL” button to return to the Main Menu.
BTN:
To select the button mode, move the cursor right until it is under Btn. Press the up or down key to select
between the following five possible modes. The screen will change to the following:
OFF:
Description: Btn
Button Off :
OFF
This mode disables the handlebar button. Nitrous can still be activated with TPS or TPS plus RPM.
N2O:
Description: Btn
N2O + Fuel :
N2O
This mode adds nitrous and fuel when the button is pressed. When the button is pressed, nitrous will be
activated regardless of the TPS or RPM settings.
TUN:
Description: Btn
Fuel only :
TUN
When the handlebar button is pressed in TUN mode, only fuel is added. This is used to experiment
with fuel addition and subtraction while riding. Press the button at a certain RPM or under a certain
load to see whether your addition or subtraction is beneficial. This cannot be used in combination with
N2O operation. Be sure TPS and RPM triggering are OFF when using this feature. Also, set the fuel
number in the N2O menu to a low value such as two or minus two.
CAP:
Description: Btn
StatCapture:
CAP
In CAP mode, the handlebar button is used to capture current data. When pressed, the Stats Capture
screen will be displayed, but the data will not be frozen until the button is released. After a capture,
pressing the Right-Arrow button will erase the captured data and return to Run Mode.
ARM:
Description: Btn
On for N2O :
ARM
By using a pushbutton (momentary), toggle, rocker, or slide switch connected to the button input, the
nitrous system can be armed or disarmed. When the switch is closed the system is armed and ready.
Then, depending upon other configuration settings, either the TPS or TPS with RPM can activate the
nitrous system. When the switch is open, the system is disarmed so neither TPS nor RPM will result
in nitrous activation.
Nitrous activation idea: One way to use the button for nitrous activation and to have the RPM limiting feature
(to prevent hitting the rev-limiter), set Btn to ARM, TPS to ON (with a low threshold), and RPM to ON (with
desired Min/Max settings).
Press the Left or Right Arrow to return to the N2O menu or push the “SEL” button to return to the Main
Menu.