BoonDocker ARCTIC CAT: 700/800 Turbo - Manual (Page 7)

BoonDocker – 1585 Hollipark Dr. Idaho Falls, ID 83401 – (208) 542-4411
website: www.boondockers.com - email: [email protected]
Revised 12-01-00 Page 7 of 15
1.B Boost Adjustments M1L

Lo Md HI
PSI 00 00 00
Lo
This adjustment is used when you are on boost at one third throttle or less.
MD
This adjustment is used when you are on boost at one third to two thirds throttle.
Hi
This adjustment is used when you are on boost at two thirds throttle or higher.
1.C Accel Pump Adjustments M1L

AM DR Sens
ACEL 00 00 00
.
AM
Amount of fuel to be added/subtracted during acceleration
DR
Duration in engine cycles to make acceleration adjustment
Sens
Accelerator pump Sensitivity. Larger values are Less sensitive (throttle must be moved more). Value of
Zero will cause accelerator pump to always be on! Typical values are between 5 and 20.
2. Map / Setup Menus
From the Main Menu, select Map1U to go to the Map Menu (shown below). This screen is used to
Load/Copy/Lock/Unlock saved “maps” that contain fuel and N2O settings. Five maps can be used (Map1-Map5).
Lock ULock StUp

Load Copy Quit
2.1 Map: Load
When a new map is loaded, the current adjustment settings will be changed to the values from that map. To load a
new Map, first move the cursor to select Load and press “SEL”. The following Load/Lock Menu will be
displayed:
Load 1 2 3 4 5→Q
Lock L U U U U Q
Load 1-5
Selects which map to load
Lock
L = Locked, U = Unlocked, applied to the map number the L or U is under
Q
Quits this menu
Use the Up/Down and Left/Right Arrow keys to move the cursor around. To load a new map, move the cursor to
the desired map number and press “SEL.” The map will be loaded and the Main Menu will be displayed. When a
map is loaded, the Mx (x is the map number) that is displayed in the Main and Fuel menus will show the loaded
map number as a reminder.
To quickly Lock or Unlock maps, move the cursor down to the Lock row, place the cursor under the L or U by the
desired map number, and press “SEL” to change a U (Unlocked) to an L (Locked) or vice versa.
Select Q to Quit and return to the Main Menu.
2.2 Map: Copy
To copy a map, first select Copy from the Map Menu. The following Copy/Lock Menu will be displayed:
Copy 1 2 3 4 5→Q
Lock L U U U U Q
Copy 1-5
Selects which map to copy the current map TO
Lock
L = Locked, U = Unlocked
Q
Quits this menu