BoonDocker SKI-DOO: 2011-12 XP E-TEC 800 - Manual (Page 4)

BoonDocker tollfree: 877-522-7805 local: 208-542-4411 fax: 208-524-7381 www.boondockers.com 4
13. Remove air box by sliding it vertically off the throttle
body adaptor plate.
14. Remove clamps and remove throttle body adaptor
plate from the throttle bodies.
15. Remove the throttle bodies and reed cages. Install
the included half reeds on top of the factory reeds.
The half-reeds with slotted holes install on the
matching inside reeds and the standard hole half-
reeds on the matching outer reeds.
16. Connect the Control Box ADA harness to the Throttle
Position Sensor (TPS) on the mag end of the throttle
bodies. The factory connector should be removed
and the harness plugged inline.
17. Connect the Control Box Injector harness to the
stock coil connectors. Similar to the TPS connection
in step 15 these connectors plug inline. It does not
matter which of the two coil connectors on the CB
INJ harness plug to the stock Coil connectors. They
can be connected either way.
18. Install the Power Adaptor cable to the machine. Bolt
the ground connector to the stock ground point on
the footwell. Plug the spade connector into the fuse
holder on the oil tank.