BoonDocker SKI-DOO: 2013-14 XM E-TEC 800 - Manual (Page 7)

Revised 12/28/2012 Page 7 of 10
www.boondockers.com………………..... ……….………………....877-522-7805
31.Install the turbo assembly as seen in the pic-
ture. Install the spring supplied for turbo bracket
tab to bulk head spring tab. 32.Route the inside coolant line under the bulk
head bracket as seen. Route up to the back side
of coolant bottle.
33.Remove the small coolant line from the back
of the coolant bottle. Then route to the coolant
hose you just removed. Make sure you secure
hose so it won’t chaff wires or hose. 34.Route the outside turbo coolant hose under
the bulk head cross member to coolant bottle.
Clean the belly pan & attach oil pump Velcro.
Heat the glue on the Velcro for best adhesion.
35.Route & hook up power for oil pump to
power harness. Route coolant hose to coolant
bottle. Zip tie the hose & power harness away
from any hazard. Tighten coolant hose clamps. 36.Remove the pipe off of the doughnut apply
high temp silicone on both sides of the doughnut
& reinstall pipe. Triple up the springs on the
pipe as seen in the picture.