BoonDocker SKI-DOO: 2013-14 XM E-TEC 800 User Manual
Page 2
Revised 12/28/2012
Page 2 of 10
www.boondockers.com……………….....
……….………………....877-522-7805
1.
Remove the instrument, side panels & Hood/head
light/air box module. Remove the Air box at throttle
bodies, seat, tank & body panels.
2.Carfuly
remove temp sensor for later use in turbo
install.
3.
Remove the stock muffler/can & EGT. Remove the
stock rubber muffler/can isolators from the bottom of
the muffler/can.
4.
Remove hood from headlight assembly & flip
upside down. Break off the weld dots on the air box
assembly. Pull apart the air box assembly. Discard
the lower air box & white air box tube.
5.Cut the upper air box matching both sides on
the cut (as seen in picture).
6.Cut the upper hood/air box assembly as seen in
picture for clearance purposes. Cut remaining
weld dots off of the upper air box.