CDI Torque SURETEST AND 600TL Torque Calibration System - Manual (Page 42)

TORQUE CALIBRATION SYSTEM SETUP CHAPTER 4
Displaying or Downloading Data List
Torque measurements stored in the data list also include a date and time stamp. For additional
information on setting up printer or PC ports, refer to Chapter 3—Set Up and Programming in this
manual.
Displaying Data List
1. Press Data (F1) in select Transducer screen or (F2) in measurements mode.
The display reads:
2. Torque Units of measure are displayed at top of the display with present memory
location/total memory locations to the right. Torque readings are to the left of the Time
and Date. The last reading is highlighted.
3. Use Up (
↑) or Down (↓) key to view the data list.
4. Press Escape (F1) to return to measurements mode.
Downloading Data List to Printer
1. Press Data (F1) from select Transducer screen or (F2) in measurements mode.
2. Press Send (F4).
The display reads:
Figure 4-5: Data Download Display.
3. To download the raw data list, select Send raw data then Press Enter (
↵).
4. To download the data list plus date-time stamp, press Down (
↓) to select
Send Data, time/date then press Enter (
↵) to print.
5. Press Escape (F1) to return to measurements mode.
4-10