CDI Torque SURETEST AND 600TL Torque Calibration System - Manual (Page 37)

TORQUE CALIBRATION SYSTEM SETUP CHAPTER 4
Figure 4-1: Power Tool Test Setup
A - Power Tool
B - Joint Rate Simulator
C - Transducer
7. Couple the power tool to the joint rate simulator using the appropriate accessory adaptors
and bit.
8. While holding the power tool drive perfectly in-line with the transducer drive, energize
the tool until its motor stalls or, if featured, the tool clutch slips.
9. Remove the power tool. Loosen the joint rate simulator load screw.
10. Repeat steps 7 through 9 twice again to exercise the tool-simulator assembly and the
SURETEST transducer.
11. Remove the power tool from the loader-transducer and press Zerotare.
12.
Press Select Mode to select POWER (TOOL) mode.
13. While holding the power tool drive perfectly in-line with the transducer drive, reinstall
the tool onto the simulator and energize the tool until its motor stalls or, if featured, the
4-5