CDI Torque SURETEST AND 600TL Torque Calibration System - Manual (Page 28)

SETUP AND PROGRAMMING CHAPTER 3
Setup Programming
Setting up Date and Time
1. Press (Setup).
2. Scroll Down (
↓) to select Clock Adjust. Press Enter (↵).
The display reads:
3.
Use Left (
←) or Right (→) (Up (↑) or Down (↓) Cursor to select (reverse video)
the date/time element to be changed.
4. Increment or decrement the date/time element by repeatedly pushing Up (
↑) or
Down (
↓) cursor. Push and hold Up (↑) or Down (↓) cursor to change the display
quickly.
(day to month to year and seconds to minutes to hours will roll over but not back)
5. Press ENTER (
↵) to update date and time and to return to measurements mode.
Setting Up High and Low Limits Alert
Use HIGH and LOW Limits Alert to protect the tool under test or serve as a fastener
installation torque preset alert. The SURETEST produces a constant audible tone when
the input torque exceeds the LOW limit. It then produces a pulsating tone when the input
torque exceeds the HIGH limit.
It is necessary to program these limits if statistical analysis is to draw a histogram, which
includes reporting out-of-limit parameters.
Changing transducers does not automatically change HIGH and LOW limits.
Setting High or Low Torque Limits
1. Press (Setup).
2. Scroll Down (
↓) to select Edit limits.
The display reads:
3-5