CDI Torque SURETEST AND 600TL Torque Calibration System - Manual (Page 4)

Using this Manual
This manual contains instructions for use and setup of the SURETEST 5000-3 Torque
Calibration System. A table of contents and a table of illustrations are provided to make
this manual easy to use.
Some of the information shown in text or illustrations is obtained using optional
equipment.
Conventions
This section contains a list of conventions used in text.
Chapter References
Additional information in text is referenced by chapter number and section name.
Example:
For testing procedures refer to Chapter 4—Using the SURETEST 5000-3
System.
Equipment Damage
The possibility of damage to vehicle or equipment is introduced by a signal word
indicating this condition.
Example:
IMPORTANT
The connector on single transducer cables contains the EEPROM calibration memory
chip. Never attempt to remove the connector from the transducer. It is installed with a
permanent adhesive.
Safety Messages
Safety messages are provided to help prevent personal injury and equipment
damage. All safety messages are introduced by a signal word indicating the
hazard level. The types of safety messages are: Danger, Warning and Caution.
TABLE OF CONTENTS 3