CDI Torque SURETEST AND 600TL Torque Calibration System - Manual (Page 31)

SETUP AND PROGRAMMING CHAPTER 3
Clear Single Memory Location
Use the procedure in this section to clear a single memory location.
1. Press (Data) (F1) to enter data list display. The display reads:
2. The units and present memory location are given on the top line. The total number
of memory locations are to the right -- separated by a forward slash (/). The bar
graph to the right of the data list indicates how far in the list the current data display
is positioned. Use the Up (
↑) or Down (↓) Cursor to select data.
+018.82 in.lb., Time: 09:46 Date: July 01, 1999 ; Location 9 of 11
3. Press (DEL 1) (F5) to delete one data entry (reverse video).
The display automatically updates, (decrements by one) the total memory locations
on the top line.
Clear All Memory Locations
Use the same above procedure for single memory location. Press (Clear) (F6) to clear
all memory locations. The following warning appears:
Select “Yes” to clear all memory.
An audible alarm sounds momentarily. The SURETEST automatically returns to
measurements mode.
Setting Up Printer Port
The SURETEST is equipped with two RS-232 serial communications ports for use with
an external printer or personal computer. The transfer rate is programmable (for printer
port only) from 300 to 19.2K baud rate with 8 data bits, 1 stop bit and no parity. The
recommended default is 19200 baud for Optional Port and 9600 for Serial Printer.
Communication setup as: (300 – 19200), 8 Data bits, 1 Stop Bit, No Parity
Connect the Printer port to a computer or printer. All (serial) communications will take
place under User’s command(s) Edit Parameters set-up mode.
3-8