Catler JE 4010 - Manual (Page 11)

9
OPERATING YOUR JE 4010 JUICE EXTRACTOR
Speed selector table
Fruit / Vegetables
Suggested
Speed
Apples 5
Apricots (stone removed) 2
Beetroot (cleaned,
trimmed)
5
Blueberries 1
Broccoli 4
Brussel sprouts (trimmed) 5
Cabbage
4
Carrots (cleaned) 5
Caulifl ower
4
Celery 5
Cucumber, peeled 2
Cucumber, soft skinned 4
Fennel 5
Grapes (seedless) 1
Kiwi fruit (peeled) 2
Mangoes (peeled, stone
removed)
2
Melons (peeled) 1
Nectarines (stone
removed)
2
Oranges (peeled) 3
Peaches (stone removed) 2
Pears hard (stalks removed) 5
Pears soft (stalks removed) 2
Pineapple (peeled) 5
Plums (stone removed) 2
Raspberries
1
Tomatoes 1
Watermelon (peeled) 1
Use the speed selector table located on the pulp
container for a quick and convenient juicing
reference.
NOTE
Step 4
Press the ‘On/Off ’ switch on the control panel
to ‘On’. The juicer will start to operate at the
selected speed. The speed can be changed
at any time during the juicing process by
adjusting the variable speed control dial.
After 3 minutes, the LCD display will
automatically turn off if the ‘On/Off ’ switch is
not turned ‚On‘, or a speed is not selected.
NOTE
Step 5
With the motor running, place food into the
feed chute and use the food pusher to gently
guide food down. To extract the maximum
amount of juice, always push the food pusher
down slowly.
The JE 4010 Juice Extractor will automatically
stop operating if the motor is stalled for more
than 10 seconds. This is a safety feature.
Either too much food is being processed at
one time or the pieces are not small enough.
Try trimming food, cutting food into smaller
pieces of even size and/or processing a smaller
amount per batch.
To continue juicing, reset the JE 4010 Juice
Extractor Plus by pressing the ‘On/Off ’ switch
on the control panel to ‘Off ’, then clear the feed
chute , fi nally turn the appliance back on by
pressing the ‘On/Off ’ switch to ‘On’.
NOTE